[1.02.12]
- changed the code of RF TAG CountDown
- added the Error flag about LAM Thread operation
[1.02.10]
- added the function to show the progress to ###% format on LCD panel when Initialize & reInitialize(Case Open & Close)
- fixed the code of RF TAG R/W communication
(When RF communication fails, register to hop and recover the code error)
- fixed the bug in EXT communication
[1.01.13]
- Supported 600 DPI PrintHead (S81H)
- Changed to allow the SBSCommand while preheating process
- Changed the Separation Mode 3
- Changed the default value of Lock
- Changed the SBSCardOut function when BendRemedy installed
- Changed the logic of YMCKK ribbon searching
[ 1.02.90 ]
- fixed the function to set the error card bin (3rd tray) if the compact multi-hopper is installed and
the inner tray option is activated when the initialization and Card Out command to the front side
[ 1.02.87 ]
- fixed the function to send the data on the normal readable MS track except for the track that MS read error occurs
- added the function to adjust the RMP value automatically when YMCKO (100) ribbon is installed
- changed the criteria of color detect level when P-ribbon is installed to fix the YMCKOK ribbon issue with SMART-31
- added the function to print a long card with up to 120mm width
- added the function to print a rewritable card without erasing on SMART-31R
[ 1.02.73 ]
- added the high-speed mode when printing rewritable card first time (6 - 7sec)
[ 1.02.72 ]
- supported the extra internal hopper in the SMART-70 multi-hopper (KIOSK)
- added the function to control the SMART-70 multi-hopper directly (KIOSK)
[ 1.02.64 ]
- fixed the bug that print position on panel is shifted depending on the amount of ribbon remaining.
- fixed the bug that printing wasn't counted when 600, 1200 DPI with K ribbon
- supported the YMCKOKR ribbon
- supported the compact multi hopper on the driver
- added the function to set the direction of the cleaning process
- added the function to set the Public key in the Laminator
- added the logic to occur init error when flipper out sensor detects a card while initializing
- modified the option to fix the direction of cleaning to backside if the multi-hopper is installed
- modified the option to consider the panel is black if the RGB value is under 85% with BO ribbon
- modified the logic that considers the card is inserted after Card In action even though Card In sensor doesn't detect a card on SBS mode & portable mode
- modified the logic to enter the cleaning process that Top cover is opened and ribbon is removed when booting up while right LED button is pushing
- fixed the bug that the K ribbon doesn't count the printing issue on 600 & 1200 DPI
[1.00.38]
- Enhanced the RF TAG R/W communication code (Increased retry count when failed)
- Applied the temperature profile while Heating (Enhanced the waiting time of heating)
- Changed the waiting time of heating to the lami temperature, 90 -> 55sec
[1.00.36]
- Supported the Bend Remedy module
[1.00.35]
- Added the BaudRate 19200 Setting (Force Mode)
- Added the function to get the heating temperature of laminator from Printer
- Modified the action to do nothing when opening a Hopper Cartridge under 'Count Zero' status
[ 0.02.07 ]
- The S51L can work even though the laminating film is not inserted or the film balance is 0.
(S51 Printer firmware should be 1.02.72 or above)